Guest anchoring is configured for a newly created SSID for your company. It has been noticed that the mobility tunnels
are not up, and that MPING fails from your foreign WLC to the anchor WLC. What is the reason that it is failing?

A customer is running a guest WLAN with a foreign/export-anchor setup. There is one anchor WLC in the US and two in
Europe. Anchor WLC priorities are used to prefer local anchors. During a routine network audit, it is discovered that a
large number of guest client sessions in the US are anchored to the WLCs in Europe. Which reason explains this
behavior?

An engineer has configured guest anchoring for a newly created SSD however, the mobility tunnels are not up, and
EPING is failing from the foreign WLC to the anchor WLC. Which traffic flow must be allowed at the firewall to enable
the communication?

A network engineer is working on a design for a wireless network that must support data, voice, and location services.
To support these services, which access point placement must the engineer use?

A wireless network consultant must assess an existing wireless LAN controller. Which section must the consultant
check before replacing the old APs with APs that are IEEE 802.11ac-capable?

An engineer must create data link redundancy for the company\\’s Cisco Wireless LAN controller. The engineer has
decided to configure LAG-based redundancy instead of port-based redundancy. Which three features of LAG-based
did redundancy influence this decision? (Choose three.)

A customer is concerned about mesh backhaul link security. Which level of ecnryption does the backhaul link use?

What is the recommended cell overlap when designing a wireless network for Cisco Hyperlocation?

Refer to the exhibit. Which two statements about Cisco Prime Infrastructure are true? (Choose two.)

An engineer must create data-link redundancy for the company\\’s Cisco Wireless LAN Controller. The engineer has
decided to configure LAG-based redundancy instead of port-based redundancy. Which three features of LAG-based
redundancy influenced this decision? (Choose three.)

During a client roaming event, which device is responsible for communicating the new Layer 2 EID mapping of a
wireless supplicant to the fabric domain?

Which non-Wi-Fi interferer can be identified by Metageek Chanalyzer?

Where must the APs be mounted when used in a high-density wireless network to provide 6 dB to 20 dB of attenuation
to a cell?