New 200-301 Dumps Practice Questions, Candidates Rely On This To Pass

New 200-301 Dumps Practice

For IT practitioners, it is always his quest to pass the Cisco CCNA 200-301 exam to obtain a certificate at any time. The new 200-301 dumps practice questions can help achieve this goal in a relaxed way.

As soon as the new 200-301 dumps (there are two ways to practice methods the Cisco 200-301 dumps, PDF and VCE!) were well received by many candidates. This is the safest way to practice methods and the best solution to successfully pass the Cisco CCNA 200-301 exam!

Here, not only will you be told how to pass the 200-301 exam but also be provided with new free practice questions, new.

New 200-301 dumps online share 200-301 practice questions 14-27:

From: Pass4itsure
Number of exam questions: 14-27
Type: Free
Associated certification: CCNA

The Cisco CCNA (200-301) exam is 120 minutes long and consists of 100-120 questions. Questions can be multiple-choice, drag-and-drop, mock, and other types.

Question 14:

Refer to the exhibit.

200-301 practice questions 14

Which type of route does R1 use to reach host

A. default route

B. network route

C. host route

D. floating static route

Correct Answer: B

By process of elimination, the answer must be B, although I think the PC diagram with the /25 might be confusing to some people.

The default route given is for any traffic not matching a known route and the host is known, therefore it cannot be A.

It cannot be C because there are no /32, single hosts in the table

It cannot be D because a floating static route is used for higher administrative distances are none are present in this scenario.

Question 15:

What is the functionality of the control plane in the network?

A. It looks up an egress interface in the forwarding information base.

B. It forwards traffic to the next hop.

C. It exchanges topology information with other routers.

D. It provides CLI access to the network device.

Correct Answer: C

Question 16:

Refer to the exhibit. Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.)

200-301 practice questions 16

A. R1(config)#router ospf 1 R1(config-router)#router-id

B. R1(config)#interface FastEthernet 0/0 R1(config-if)#ip ospf priority 200

C. R3(config)#interface FastEthernet 0/0 R3(config-if)#ip ospf priority 0

D. R1(config)#interface FastEthernet 0/0 R1(config-if)#ip ospf priority 0

E. R3(config)#interface fastethernet 0/0 R3(config-if)#ip ospf priority 200

Correct Answer: BC

Question 17:

Which set of actions satisfy the requirement for multifactor authentication?

A. The user enters a username and password and then re-enters the credentials on a second screen.

B. The user swipes a key fob and then clicks through an email link.

C. The user enters a username and password and then clicks a notification in an authentication app on a mobile device.

D. The user enters a PIN into an RSA token and then enters the displayed RSA key on a login screen.

Correct Answer: C

This is an example of how two-factor authentication (2FA) works:

1. The user logs in to the website or service with their username and password.

2. The password is validated by an authentication server and, if correct, the user becomes eligible for the second factor.

3. The authentication server sends a unique code to the user\’s second-factor method (such as a smartphone app).

4. The user confirms their identity by providing additional authentication for their second-factor method.

Question 18:

Refer to the exhibit. What is the result if Gig1/11 receives an STP BPDU?

200-301 practice questions 18

A. The port transitions to STP blocking

B. The port transitions to the root port

C. The port immediately transitions to STP forwarding.

D. The port goes into an error-disable state

Correct Answer: D

Question 19:

Refer to the exhibit.

200-301 practice questions 19

A network engineer must block access for all computers on VLAN 20 to the web server via HTTP All other computers must be able to access the web server.

200-301 practice questions 19-2

Which configuration when applied to switch A accomplishes this task?

A. Option A

B. Option B

C. Option C

D. Option D

Correct Answer: B

Question 20:

What is the same for both copper and fiber interfaces when using SFP modules?

A. They support an inline optical attenuator to enhance signal strength

B. They provide minimal interruption to services by being hot-swappable

C. They offer reliable bandwidth of up to 100 Mbps in half-duplex mode

D. They accommodate single-mode and multi-mode in a single module

Correct Answer: B

Question 21:

What are two reasons a switch experiences frame flooding? (Choose two.)

A. A defective patch cable is connected to the switch port

B. Topology changes are occurring within spanning-tree

C. An aged MAC (able entry is causing excessive updates

D. Port security is configured globally

E. The forwarding table has overflowed

Correct Answer: AB

Question 22:

What describes a northbound REST API for SDN?

A. network-element-facing interface for GET, POST, PUT, and DELETE methods

B. application-facing interface for SNMP GET requests

C. application-facing interface for GET, POST, PUT, and DELETE methods

D. network-element-facing interface for the control and data planes

Correct Answer: C

Question 23:

Which two QoS tools are used to guarantee minimum bandwidth to certain traffic ?(choose two)






Correct Answer: CE

Question 24:


Drag and chop the TCP/IP protocols from the left onto their primary transmission protocols on the right.

Select and Place:

200-301 practice questions 24

Correct Answer:

200-301 practice questions 24-2

Question 25:


Drag and drop the statements about AAA services from the left onto the corresponding AAA services on the right. Not all options are used.

Select and Place:

200-301 practice questions 25

Correct Answer:

200-301 practice questions 25-2

Question 26:

Refer to the exhibit. Which command configures OSPF on the point-to-point link between routers R1 and R2?

200-301 practice questions 26

A. router-id

B. neighbor cost 180

C. network area 0

D. ip ospf priority 100

Correct Answer: C

Question 27:

What is the purpose of the IP address hcp command?

A. to configure an Interface as a DHCP server

B. to configure an interface as a DHCP helper

C. to configure an interface as a DHCP relay

D. to configure an interface as a DHCP client

Correct Answer: D

This command enables the DHCP client on the interface and removes all manually-configured addresses on the interface.

Last updated 200-301 exam questions q1-q13

200-301 new exam resource sharing

Video mode, you love it:

Document mode, you love it:

Book mode, you love it:

Of course, there are more than just these good learning materials, and you are welcome to add more.

Finally, answer your questions about the Cisco CCNA 200-301 exam

How do I practice in such an efficient manner to conquer the CCNA 200-301 exam in 2024?

As mentioned at the beginning, using the new 200-301 dumps practice questions can help achieve this goal.

Is CCNA 200-301 worth it?

It’s worth it. Passing the exam and getting the certificate will make you very competitive. Therefore, you should complete the CCNA 200-301 exam.

Many candidates have verified for you that using the new 200-301 dumps practice questions to prepare for the exam is effective.

Obedient, go and download the new 200-301 dumps practice questions now (Cisco 200-301 dumps has two practice Xi methods, PDF and VCE!) to win the exam easily.

Author: guydster