HomeQuizzes & Surveysfree Cisco 300-425 exam questions to pass 300-425 exam free Cisco 300-425 exam questions to pass 300-425 exam Welcome to your free Cisco 300-425 exam questions to pass 300-425 exam QUESTION 1 Guest anchoring is configured for a newly created SSID for your company. It has been noticed that the mobility tunnelsare not up, and that MPING fails from your foreign WLC to the anchor WLC. What is the reason that it is failing? A. A rule is needed at the firewall to allow UDP port 16666 for communication to work. B. A rule is needed at the firewall to allow UDP port 97 for communication to work. C. A rule is needed at the firewall to allow TCP port 97 for communication to work. D. A rule is needed at the firewall to allow TCP port 16666 for communication to work. None QUESTION 2 A customer is running a guest WLAN with a foreign/export-anchor setup. There is one anchor WLC in the US and two inEurope. Anchor WLC priorities are used to prefer local anchors. During a routine network audit, it is discovered that alarge number of guest client sessions in the US are anchored to the WLCs in Europe. Which reason explains thisbehavior? A. The foreign WLC failed and recovered. B. The US anchor WLC failed and recovered. C. The US anchor WLC is anchored to itself with a priority value of zero. D. The anchor WLC is in the same mobility group. None QUESTION 3 An engineer has configured guest anchoring for a newly created SSD however, the mobility tunnels are not up, andEPING is failing from the foreign WLC to the anchor WLC. Which traffic flow must be allowed at the firewall to enablethe communication? A. UDP port 16666 B. IP protocol 97 C. UDP port 97 D. TCP port 97 None QUESTION 4 A network engineer is working on a design for a wireless network that must support data, voice, and location services.To support these services, which access point placement must the engineer use? A. corner only B. perimeter and corner C. perimeter only D. indoor and outdoor None QUESTION 5 A wireless network consultant must assess an existing wireless LAN controller. Which section must the consultantcheck before replacing the old APs with APs that are IEEE 802.11ac-capable? A. number of AP licenses B. controller PSU C. throughput capacity D. software version None QUESTION 6 An engineer must create data link redundancy for the company\\'s Cisco Wireless LAN controller. The engineer hasdecided to configure LAG-based redundancy instead of port-based redundancy. Which three features of LAG-baseddid redundancy influence this decision? (Choose three.) A. Packets are always sent out on the same port they are received on. B. All interface traffic passes as long as one port is up. C. The same port has multiple untagged dynamic interfaces. D. Interface connection to two separate nonstacked switches is available. E. Full bandwidth of all links is available. F. Ports are grouped into multiple LAGs. QUESTION 7 A customer is concerned about mesh backhaul link security. Which level of ecnryption does the backhaul link use? A. hash B. AES C. WEP D. 3DES None QUESTION 8 What is the recommended cell overlap when designing a wireless network for Cisco Hyperlocation? A. 20% B. 30% C. 40% D. 50% None QUESTION 9 Refer to the exhibit. Which two statements about Cisco Prime Infrastructure are true? (Choose two.) A. It presents the recommended number of APs for the selected coverage area based on the selections made. B. Planning mode requires a special license in Cisco Prime Infrastructure. C. It shows the map editor feature in Cisco Prime Infrastructure. D. Controllers must be synchronized with Cisco Prime Infrastructure for planning mode to work. E. It shows the planning mode feature in Cisco Prime Infrastructure. QUESTION 10 An engineer must create data-link redundancy for the company\\'s Cisco Wireless LAN Controller. The engineer hasdecided to configure LAG-based redundancy instead of port-based redundancy. Which three features of LAG-basedredundancy influenced this decision? (Choose three.) A. Packets are always sent out on the same port they are received on. B. All interface traffic passes as long as one port is up. C. The same port has multiple untagged dynamics interfaces. D. Interface connection to two separate nonstacked switches is available. E. Full bandwidth of all links is available. F. Ports are grouped into multiple LAGs. QUESTION 11 During a client roaming event, which device is responsible for communicating the new Layer 2 EID mapping of awireless supplicant to the fabric domain? A. WLC B. BN C. CP2 D. CP1 None QUESTION 12 Which non-Wi-Fi interferer can be identified by Metageek Chanalyzer? A. PDAs B. jammers C. smartphones D. printers None QUESTION 13 Where must the APs be mounted when used in a high-density wireless network to provide 6 dB to 20 dB of attenuationto a cell? A. in the aisle B. under the seat C. above the stage D. under the stage None Time's up
